empty reports.ini / ala stops working after initial run

General discussions about Advanced Log Analyzer
Post Reply
jclark@clarkdataservices.
Posts: 3
Joined: Sat Feb 26, 2005 11:29 pm

empty reports.ini / ala stops working after initial run

Post by jclark@clarkdataservices. » Sat Feb 26, 2005 11:33 pm

I'm running ALA 1.5 on W2K Server. If I reboot the server, run ALA from the Windows UI everything runs fine. At some point while trying to run the command line option using the /all switch, the reports.ini is blown away all my output is produced without any reports.

Anyone have a clue to what is going on?

Abacre
Site Admin
Posts: 1198
Joined: Mon Jan 31, 2005 5:32 pm
Contact:

Post by Abacre » Sun Feb 27, 2005 7:33 pm

We will try to test it on Monday.
Kind regards,
Abacre Limited
http://www.abacre.com
support@abacre.com

jclark@clarkdataservices.
Posts: 3
Joined: Sat Feb 26, 2005 11:29 pm

empty reports.ini / ala stops working after initial run

Post by jclark@clarkdataservices. » Wed Mar 30, 2005 7:22 pm

Any luck testing?

Abacre
Site Admin
Posts: 1198
Joined: Mon Jan 31, 2005 5:32 pm
Contact:

Post by Abacre » Wed Mar 30, 2005 7:59 pm

Hi,

sorry, not yet, I will force this question tomorrow morning.

Roman

Abacre
Site Admin
Posts: 1198
Joined: Mon Jan 31, 2005 5:32 pm
Contact:

Post by Abacre » Fri Apr 01, 2005 9:22 am

Hi,

I need more information. I tested ALA with the following command
line:
ALA.exe -analyze:all

But it works fine. I mean that reports are produced carefully.
What do you mean about reports.ini file "blown away"?
When ALA started in command line is Reports tab empty or not?
I mean are reports loaded or not?

There is one trick: when ALA is started with command line parameters
it produces report files into needed destination folder.
But ALA does not navigate its browser (Results tab) to reports
index.htm page. It was made in order to speedup work of ALA when
working with command line parameters.
Kind regards,
Abacre Limited
http://www.abacre.com
support@abacre.com

jclark@clarkdataservices.
Posts: 3
Joined: Sat Feb 26, 2005 11:29 pm

empty reports.ini / ala stops working after initial run

Post by jclark@clarkdataservices. » Mon Jun 06, 2005 10:20 pm

(Sorry it took so long to get back to you, but I only have a little time to dedicate to this) .....

What I mean by the "reports blown away" is the reports.ini file is completely empty. When the output is generated it is like no reports are selected.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests