Page 1 of 1

epson pole display

Posted: Thu Nov 22, 2007 1:58 am
by tdrews
I am using Vista Ultimate and am having trouble with the pole display. I can not get it to work properly. The pole display is an Epson DM-D110. I keep getting an error message stating it is not defined. I used the help topics and have not found the program OPOS that it says is in the start up menu. I have tried downloading the programs from the web like the help topic has told me to no avail. Can anyone help with this issue?

Re: epson pole display

Posted: Thu Nov 22, 2007 11:55 am
by Abacre
You have to install CCO OPOS drivers before using your pole.

In help files we say that you may download CCO OPOS drivers from the following location:
or you can use direct download link:

Which link did you try?

We tried both links and both are working.

Re: epson pole display

Posted: Thu Nov 22, 2007 4:36 pm
by tdrews
I did run the files but still cannot get the pole to work. I still get "Logical Device Name for pole not Specified."

Re: epson pole display

Posted: Thu Nov 22, 2007 4:57 pm
by Abacre
After installation of CCO OPOS drivers you should install OPOS drivers supplied with manufacturer of your pole display.
Then you should run OPOS configuration utility of the manufacturer.
Using this utility you should specify Logical Device Name for you pole display. It may be any string. You should choose it yourself.
After that you should go to ARPOS - Bill Configuration Pole and Cash Drawer
and specify this Logical Device Name which you defined for the pole on previous step.
This procedure is already explained in the documentation. But I give it here in "compressed"/short way.