Partner printer setup

General discussions about Abacre Restaurant Point of Sale
Post Reply
patgiese
Posts: 3
Joined: Tue Apr 10, 2007 3:26 pm

Partner printer setup

Post by patgiese »

I am trying to set up a partner system with a partner RP-210 printer. What are the correct drivers and what font should be used. I have tried everything I can find and nothing seams to work. I am currently trying the current Epson APD drives and print test produces garbarge at a very slow rate (1 line a minute or more)
Thanks,
Pat

patgiese
Posts: 3
Joined: Tue Apr 10, 2007 3:26 pm

Post by patgiese »

I have installed the OPOS drivers from Partner. Print test in the setup utility work as does the print test program. When I try to print out of Abacre I receive message "Error during printing (EIntfCastError) Interface not supported"
Thanks,
Pat

Abacre
Site Admin
Posts: 1223
Joined: Mon Jan 31, 2005 5:32 pm

Post by Abacre »

Please read the page:
http://www.abacre.com/restaurantpos/man ... driver.htm

You have to also install CCO OPOS drivers.

So you should finally have CCO OPOS + Partner OPOS drivers.
Kind regards,
Abacre Limited
http://www.abacre.com
support@abacre.com

patgiese
Posts: 3
Joined: Tue Apr 10, 2007 3:26 pm

Post by patgiese »

I followed the directions and downloaded the CCO OPOS drivers and the EPSON OPOS drivers and all of the EPSON service packs. OPOS print test still works but, I still receive the "Error during printing" message. I have defined the printer as an EPSON TM-T88 III

Thanks,
Pat

Post Reply